TP-Link UH700 - COPYRIGHT & TRADEMARKS; FCC & CE Compliance; Hardware Connection

To Next Page

To Previous Page

Do not attempt to disassemble, modify or fix the hub by yourself. You run the risk of electric shock and voiding

the limited warranty. If you need service, please contact us.

Disconnect the hub from the computer before cleaning it. Do not use the liquid cleaning method.

This hub can be powered only by CE-certified computers that comply with Limited Power Source (LPS).

For best performance, the connected devices should not exceed a combined current of 4A.

TP-Link will not be held responsible for any damage to disk or hard disk data caused by improper use.

Specifications are subject to change without notice. TP-Link is a registered trademark of TP-Link Technologies

Co., Ltd. Other brands and product names are registered trademarks of their respective holders.

No part of the specifications may be reproduced in any form or by any means or used to make any derivative

such as translation, transformation, or adaptation without permission from TP-Link Technologies Co., Ltd.

FCC & CE

FCC STATEMENT

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:

1. Thsdevcennaynotcauseharmfuinterference.

2. This device must accept any interference received, including cause undesired operation. Any changes or

modifications not expressly approved by the party responsible for compliance could void the user’s authority to

operate the equipment.

CE Mark Warning

This is a class B product. In a domestic environment, this product may cause radio interference, in which

case the user may be required to take adequate measures.

Technical Support

Tel: +86 755 2650 4400

E-mail: support@tp-link.com

Web: http://www.tp-link.com/support

http://www.tp-link.com

Hardware Connection

Connect the devices as follows. The power LED will light up and the hub is ready to use.

Other manuals for TP-Link UH700