T+A MP 3100 HV User Manual

56
Pairing the FD 100 Radio Remote Control
General
The MP 3100 HV is designed for use with the FD 100 bi-directional radio
control handset. The FD 100 features an integral full-colour screen which
provides a convenient means of controlling virtually all the MP 3100 HV`s
functions, even when there is no direct line-of-sight contact with it. The handset
can also display information relating to the selected source or the medium
currently playing.
Connecting the radio aerial
Since the FD 100 operates by a radio
link, an aerial must be connected to the
MP 3100 HV. This is plugged into the
socket on the MP 3100 HV marked
‘REMOTE ANT’ (please see wiring
diagram). The aerial should be set up
free-standing using the magnetic base
supplied in the set; this ensures
maximum possible range.

Please use one of the WLAN aerials
supplied in the set; the aerials are
identical.
Pairing the FD 100
Before the MP 3100 HV can be controlled using the FD 100, the remote control
handset must first be registered to the MP 3100 HV. This process is known as
pairing, and only has to be carried out once. The procedure is as follows:
 Briefly touch the  button on the MP 3100 HV front panel to call up the
menu. Then select the menu item'FD 100 pairing'.
 Activate this selection by pressing the SELECT knob and confirm the paring
procedure by pressing the knob until the display message changes to.
'Waiting for FD 100'.
 The pairing now function remains active for thirty seconds. Carry out the
following steps within this time.
 Locate the  button on the FD 100 and hold it pressed in to open the
FD 100’s System Settings menu.
 Now select the ‘Start pairing’ item, and press the  button: the remote
control handset automatically seeks the MP 3100 HV.
 Once the device is found, you will see in the display header the on-screen
message ‘Pairing successful’. At the same time changes the menu entry of
the MP 3100 HV to 'Done'. If you wish, you can change the name of the
device at this point (e.g. 'Living room').
 Confirm the name with the  button.
 For faster access the MP 3100 HV can also be assigned to a Hotkey; this is
the next step (see FD 100 operating instructions).
 Select one - or optionally none - of the ‘F’ buttons, and confirm your choice
by pressing the  button.
 The FD 100 is now paired with the MP 3100 HV, and is ready for use.

For detailed information on using the FD 100 please refer to the operating
instructions supplied with the remote control handset.

T+A MP 3100 HV Specifications

General

Brand	T+A
Model	MP 3100 HV
Category	Media Player
Language	English