For updating the firmware of the MP 3100 HV there is a convenient method
which requires an existing Internet connection
If you are operating the MP 3100 HV in conjunction with a PA 3x00 HV, the
machine can also be updated via the HLink connection.
The wiring diagram for the machine is shown in 'Appendix A'.
The following section describes the exact method of updating the firmware in
detail.
Updating the firmware via the MP 3100 HV’s Internet connection
The basic requirement is a functioning network with router and access to a
broadband Internet connection; the system must be operating.
Switch the machine on.
Call up the System menu by pressing the button on the front panel.
Rotate the SELECT knob on the front panel to select the “Device info”
menu point, and confirm your selection by pressing the SELECT knob.
If the MP 3100 HV is connected to a PA 3x00 HV via the HLink connection,
the Select Device menu appears at this point. In this case select the device
to be updated by turning the SELECT knob, then press the SELECT knob to
confirm your choice.
(If the MP 3100 HV is not connected to a PA 3x00 HV, the Software Update
menu of the MP 3100 HV appears directly.)
Select the “Update” menu point by rotating the SELECT knob, then press
the SELECT knob to confirm your choice.
The Select option “WEB” should now be active (highlighted).
The firmware update can now be started by pressing the SELECT knob.
The screen displays the current state of progress of the update.
Once the update has been completed (duration around ten minutes) the
device automatically switches itself off and restarts.
When the machine has restarted, the update is complete.
To ensure that the update was successful, access the “Device Info” menu
point mentioned above, and check the new firmware status.
It is also possible to carry out the update process using the FD100 remote
control handset, as an alternative to operating the machine directly. The method
of operating the menu using the handset is described in the chapter entitled
“Basic settings of the MP 3100 HV” (Using the remote control handset).
To Next Page
Loading...
Need help?
General