TRACKMASTER Status Display Window
Status Display Window
You can monitor your performance in up to seven different modes in the status display
window. Press the Select key to advance to the next display mode. The status display
automatically resets to zero each time the running belt stops.
A red light next to the function indicates which information is displayed in the window.
The information available includes
• TIME—displays the amount of time elapsed for the exercise session
• DISTANCE—displays the accumulated distance for the exercise session
• PACE—displays the number of minutes needed to run one mile
• CALORIES—displays the number calories burned during the workout, based on
the weight entered into the controller
• CAL/MINUTE—displays the number of calories burned per minute
• METS—Displays the amount of METS per minute.
• HEART—When wearing a Polar
®
chest strap a blinking red heart below the
display window indicates the user's current pulse rate. (The Heart must be selected
in order to display pulse rate.)
Select Key
Press the Select key to change the display mode in the status window.
Scan Key
Press the Scan key to choose an alternating cycle of all available display modes. Each
mode displays for three seconds in the cycle.
Weight +/- Keys
Use the Weight +/- to enter user weight prior to the exercise session. The default is 150 lb.
Note: It is important to enter each user's correct weight before the exercise session
because all display calculations are based upon this number.
February 1, 2004 TMX425 Series Owner’s Manual C-3
To Next Page
Loading...
