Master Power Switch TRACKMASTER
Master Power Switch
The master power switch is located next to the power cord on the treadmill. The switch
should always be in the OFF position when the treadmill is not in use.
CAUTION Never use your foot to turn this switch ON or OFF because you could damage the switch
and void the warranty. Never plug the treadmill into its power outlet with the master
power switch in the ON position because you could cause a power surge, which could trip
the treadmill’s circuit breakers.
Start Key
Press the Start key to immediately start the belt at minimum speed.
Cool Down Key
Press the Cool Down key to initiate a 60 second cool down phase. The running belt will
gradually slow to the minimum speed and then completely stop. The incline will gradually
reset to 0%.
Stop Keys
Press either Stop key to halt the running belt within 1 to 5 seconds and reset elevation to
0%.
Speed + / - Keys
Once the running belt has started, press the “+” arrow to increase the speed. Press the “-”
arrow to decrease the speed. The display numbers for the speed will increase or decrease
slightly faster than the actual belt speed.
Speed Display Window
The speed display window shows the speed of the running belt in miles per hour (a display
calibrated for kilometers per hour is optional).
C-2 TMX425 Series Owner’s Manual February 1, 2004
To Next Page
Loading...
