Tracmaster CAMON TC07 - Procedure for Unexpected Shut down; Residual Risks of the TC07 Turf Cutter

CAMON TC07 Turf Cuer
TC07 Turf Cuer Page 13
At the end of the strip of turf, raise the liing lever to raise the blade out of the
ground.
Release the drive lever to stop the drive to the wheels and the blade.
Move the gear selector lever to the disengaged posion ‘O’.
Operate the machine only in daylight or in good arcial light.
Always be sure of foong on slopes.
Do not work the Turf Cuer on slopes of more than 20 degrees and always work
across the slope, not up and down it.
Walk never run.
Never operate the machine with defecve guards, or without safety devices, for
example deectors and or catchers in place.
Do not change the engine governor sengs or over speed the engine.
Disengage all levers, by releasing them, before starng the engine.
Start the engine carefully according to the instrucons.
Do not lt the machine when starng the engine.
Do not put hands or feet near or under the moving parts.
Never pick up or carry the machine whilst the engine is running.
Avoid operang the machine in bad weather condions especially if there is the
risk of lightning.
6.5 Procedure for Unexpected Shut Down
Release the drive lever.
Turn the engine operang switch located on the handlebars to the OFF posion.
Ensure the blade has stopped moving prior to moving the machine.
6.6 Residual Risks of the TC07 Turf Cuer
The TC07 Turf Cuer is designed to be pushed by the operator during transportaon.
It has no brake system and the operator must hold rmly onto the machine at all
mes when the machine is on sloped areas.