Tracmaster CAMON TC07 - Cutting Depth Adjustment; Machine Lifting Lever

CAMON TC07 Turf Cuer
TC07 Turf Cuer Page 7
PLEASE NOTE THAT THIS IS A TWO STAGE LEVER. THE GREY BUTTON MUST BE
DEPRESSED BEFORE THE MAIN LEVER CAN BE PULLED UP.
This lever operates both the cung blade and the driving power to the back
wheels. It does this by raising the engine speed unl a centrifugal clutch engages
and transfers the engine power to the driven components of the TC07.
Leng go of the drive lever causes the engine revoluons to drop, the centrifugal
clutch to disengage and both the engine drive and cung blade to stop moving.
5.6 Cung Depth Adjustment
The cung depth of the blade is adjusted using the two
adjuster knobs - the lower locking knob and the top
height adjustment knob. The top height adjustment knob
is connected to a length of threaded rod that is wound
into and out of the chassis. These knobs are located in
front of the handlebar mounng on the top secon of
the main chassis.
The lower knob is for locking the posion of the top knob. To adjust the depth of the
cung blade, rst loosen the lower locking knob. Once this knob is able to move
freely, you can adjust the posion of the top knob into and out of the chassis by
turning it clockwise and anclockwise.
Using the indicator scker on the thread of the top knob it is possible to choose
your required depth of cut. This ranges from 25mm to 40mm.
5.7 Machine Liing Lever
Located at the rear of
the machine, below the
handlebars, this lever allows
the operator to move the
cung blade in and out of the
ground.
1 2
BLADE OUT OF GROUND BLADE IN GROUND