Tracmaster CAMON TC07 - Cleaning; Troubleshooting; Machine

CAMON TC07 Turf Cuer
Page 16 TC07 Turf Cuer
7.4 Cleaning
Aer cleaning, parcularly if a pressure
washer has been used, ensure any
lubricaon points are re-lubricated, in
parcular the clutch system (see image
to the right).
Clean the engine with a cloth only.
Avoid spraying the engine with jets of
water as this may leak into the fuel and
ignion systems.
7.5 Troubleshoong
7.5.1 Machine
Have all serious malfuncons on the machine and engine repaired by an
authorised Tracmaster or Honda agent.
Problem Possible Cause Remedy
No drive to blade
Broken belt Replace belt
Damaged centrifugal clutch Replace clutch
Poor depth
Height lever not used
Lower the lever into cung
posion
Adjuster knobs incorrectly
set
Adjust knob posions to
allow deeper cut
Unable to engage
or disengage drive
to rear wheels
Pressure washing has
removed lubricant from the
clutch system
Lubricate the sliding clutch,
sha and chain with light
oil or penetrang uid
Avoid pressure washing the
transmission assembly
DISENGAGED
LUBRICATE
ENGAGED
LUBRICATE