13
TRAEGERGRILLS.COM
SEASONING YOUR GRILL
TO BE USED ON INITIAL FIRING ONLY. In order to ensure proper and safe operation of the grill, follow the instructions below,
first, to prime the auger (“charge” the auger tube with pellets) and, second, to season your grill (run your grill at a high temperature).
Open the hopper lid. Make sure there are no foreign
objects in the auger before adding pellets to the hopper.
With the grill in Idle mode, press and hold the “Up” and
IGNITE buttons simultaneously. The display will flash “Pri”
and the auger will begin priming.
PLUG APPEARANCE MAY VARY BY REGION.
With the Main Power switch on the back of the grill
hopper in the OFF (O) position, plug the power cord into
an appropriate grounded/earthed GFCI electrical outlet.
NOTE: Once you turn on your grill, it will enter Idle
mode, and the display’s dashed border will pulse. This
indicates your grill is awaiting a command, and is not
actively operating. The grill MUST be in Idle mode to
prime the auger.
4
2
Remove the porcelain-coated grill grate, grease drip tray,
and heat bae from the inside of the grill.
3
1
WARNING! Ground Fault Circuit Interrupter
(GFCI) protection must be provided on the circuit or
outlet used to power the grill.
To Next Page
Loading...
Need help?
General
