20
REIGNITING YOUR GRILL
DANGER! If the grill failed to light or the fire went out,
turn the Main Power switch OFF (O) and disconnect the
power cord. If the grill is still hot, allow it to cool thoroughly.
Open the door and remove all food, the porcelain-coated
grill grate, the grease drip tray, and the heat bae.
4
Plug power cord into an appropriate grounded electrical
outlet and restart the grill. Pellets should fall into the
firepot and the hot rod should begin to heat (it will start
to turn red).
USING YOUR GRILL (CONTINUED)
WARNING! If at any time the grill fails to light, or the fire in the firepot goes out while cooking or smoking and
there are sucient pellets in the pellet hopper, it is important that you follow these steps. Failure to do so may cause
a hazardous “over-firing” of your grill due to an excess of unburned pellets in the firepot.
WARNING! Afer the grill, pellets, and ash have
completely cooled, remove all unburned pellets
and ash from inside and around the firepot. (See
instructions for proper handling and disposal of
ash on page 23.)
CAUTION! Do not touch the hot rod.
1
2
3
To Next Page
Loading...
Need help?
General
