16
USING A PRESET CUSTOM COOK CYCLE (continued)
BEGINNER’S BRISKET
Probe Required.
Insert Probe in Meat.
>Back
RUN COOK CYCLE NOW?
>YES
>NO
077
°F
STEP 1: 165°F | TIME: 03:30
PROBE: 072°F
Push Ignite To Start
150
5
7
6
8
To RUN COOK CYCLE NOW, select YES at the prompt or
NO to return to the previous screen.
The display will now show the first step of your cook
program. Press IGNITE to start.
The automatic ignition and preheat cycle will begin. Once
preheating is complete, load food into the grill and close
the grill door. Big-time flavor is getting closer!
If the probe is required, you’ll be instructed to insert
the probe into your meat. Then, insert the probe plug into
the jack on the controller. A tone will sound once
the probe is recognized. To RUN COOK CYCLE NOW
now, select YES at the prompt.
NOTES:
• If the probe is not plugged in properly, the grill will beep three times. Check to make sure the probe is plugged in
properly.
• It is recommended, but not necessary, to wait until preheat cycle is complete before loading food into the grill.
• The grill door should be closed once the preheat cycle begins so that the grill can reach the desired set temperature
quickly.
CHOOSING A COOK METHOD (CONTINUED)
6236 Ironwood OM EN GLOBAL v01.indd 16 8/29/19 2:14 PM
To Next Page
Loading...
Need help?
General
