17
TRAEGER.COM
SUBSEQUENT START-UP
2
With the main power switch set to ON (I), press the center button once to
wake the grill controller. Set the desired temperature with the “Up” button.
NOTE: Once you press the IGNITE button, your Traeger® Grill will
always begin with an ignition and preheat cycle.
3
Once the desired temperature is displayed, press IGNITE. Allow grill to
preheat until desired temperature is achieved.
NOTE: If the grill fails to achieve the selected temperature, please
see “Operating Tips” on page 26 for more information.
WARNING! WHEN OPERATING THIS GRILL, MAINTAIN A
MINIMUM CLEARANCE OF 18 IN. (45.7 CM) FROM GRILL
TO COMBUSTIBLES.
CONTROLLER SHUTDOWN CYCLE
The controller for this grill comes with an automatic shutdown
cycle. When finished cooking on your grill, press and hold the
center button for 3 seconds. The display will flash “OFF” for
several seconds, then “COOL Dn” will scroll across the screen,
followed by the actual temperature of the grill, until the grill
cools down enough to put out the fire in the firepot.
While the controller is flashing “OFF,” you can cancel the
shutdown cycle by pressing and holding the center button for
two seconds.
Always allow the shutdown cycle to completely finish (goes into
standby mode) before powering o your grill at the main power switch.
The shutdown cycle ensures the fire is suppressed and the grill ignites
properly on the next use.
DANGER! TURNING OFF THE MAIN POWER SWITCH
WILL CUT POWER TO THE GRILL COMPONENTS ONLY.
WHEN SERVICING THE CONTROLLER OR ANY OTHER PARTS,
ENSURE THAT THE POWER SUPPLY IS DISCONNECTED TO AVOID
AN ELECTRICAL SHOCK HAZARD.
Make sure the grease drip tray and grease bucket are in place; then
close the grill lid.
NOTE: Review the pre-grilling checklist on page 18 before turning on
the grill.
1
4
Once preheating is complete, load food into the grill.
To Next Page
Loading...
