43
Place the rear cross bar into place
and align holes.
44
Start 8mm bolts with washers.
NOTE: DO NOT TIGHTEN HARDWARE YET.
45
With an assistant, hold the top weld-
ment in place.
.
46
Use the remaining four (4) long 8mm
bolts and washers to install the top
weldment.
47
Plastic end caps may need to be ro-
tated with pliers to fit properly
48
Start the four (4) bolts with washers
into the top weldment.
NOTE: DO NOT TIGHTEN HARDWARE YET.
To Next Page
Loading...
