OPERATION
Start a cold engine
1.
Apply thebrake.
2.
Shift the drive select lever into the neutralposition.
NOTE:
-
When the drive select lever is in the neutralposition.
-
The engine can be started in any gear if the brake is applied. However, it is recommended toshift
into neutral before starting theengine.
3.
Withyourfootofftheacceleratorpedal,starttheenginebyturningthekeyto“START”position.
NOTE: If the engine fails to start, release the key, and then try starting again. Wait a few seconds
before the next attempt. Each cranking could be as short as possible to preserve battery. Do not
crank the engine more than 5 seconds on each attempt.
4.
Seethe“EngineBrakeIn”sectionprior tooperatingtheengineforthefirsttime.
To Next Page
Loading...
