USER GUIDE
12
Calibration
For regular on-site assessment of your CMEXpert II in
moisture measurement mode, a calibration-check plate is
available from the suppliers of your CMEXpert II. Should
it be found that readings are outside the set tolerances, it
is recommended that the CMEXpert II be returned for re-
calibration. Calibration adjustments should not be carried
out by anyone other than Tramex or their authorized
service provider who will issue a calibration certicate on
completion.
Requirements for quality management and validation
procedures, such as ISO 9000 and National Standards,
have increased the need for regulation and verication
of measuring and test instruments. It is therefore
recommended that calibration of the CMEXpert II should
be checked and certied in accordance with the standards
and/or protocols laid down by your industry (usually on
an annual basis) by an authorised test provider. The name
of your nearest test provider and estimate of costs are
available on request.
To Next Page
Loading...
