12
MOISTURE ENCOUNTER 5 USER GUIDE
- Back to Top -
8. The instrument will automatically power-off after
five minutes if no button is pressed or if no change
in meter reading is detected. If a button is pressed
or the meter reading changes, the power-off will be
extended for a further five minutes.
9. To freeze readings press the HOLD/AUDIO button
once. While on Hold, the LED for the selected scale
will flash slowly. This facility is extremely useful if
readings are being taken in areas where it is difficult
to see the instrument dial. To remove freeze, press
the HOLD/AUDIO button again.
Best Practice
It is advised to avoid sliding or dragging the meter
across the surface under test. Place and press the
meter on the surface, record the reading, lift and
repeat.
To Next Page
Loading...
