36
MOISTURE ENCOUNTER 5 USER GUIDE
- Back to Top -
LIMITATIONS
The Moisture Encounter ME5 will not detect or measure
moisture through any electrically conductive materials
including metal sheeting or cladding, black EPDM roofing,
butyl roofing, aluminum siding or wet surfaces.
CALIBRATION
For regular on-site assessment of your Moisture Encoun-
ter ME5 in moisture measurement mode, a calibration-
check box is available from the suppliers of your Moisture
Encounter ME5 (Product Code: CALBOXME5). The
calibration check box allows for daily on-site calibration
checks. Should it be found that readings are outside the
set tolerances, it is recommended that the Moisture
Encounter ME5 be returned for re-calibration. Click here
for a Calibration Request. Calibration adjustments should
not be carried out by anyone other than Tramex or their
authorised service provider who will issue a calibration
certificate on completion.
Requirements for quality management and validation
procedures, such as ISO 9001, have increased the need
for regulation and verification of measuring and test
instruments. It is therefore recommended that calibra-
tion of the Moisture Encounter ME5 should be checked
and certified in accordance with the standards and/or
protocols laid down by your industry (usually on an annual
basis) by an authorized test provider. The name of your
nearest test provider and estimate of cost is available on
request.
To Next Page
Loading...
Need help?
General
