Trane Technologies GAM5B0C60M51SB User Manual

Installer’s Guide
April 2020
18-GJ04D1-15A-EN
SAFETY WARNING
Only qualified personnel should install and service the equipment. The installation, starting up, and servicing of heating, ventilating,
and air-conditioning equipment can be hazardous and requires specific knowledge and training. Improperly installed, adjusted or
altered equipment by an unqualified person could result in death or serious injury. When working on the equipment, observe all pre-
cautions in the literature and on the tags, stickers, and labels that are attached to the equipment.
Standard Coil Black Epoxy Coil
GAM5B0A18M11SB GAM5B0A18M11EA
GAM5B0A24M21SB GAM5B0A24M21EA
GAM5B0B30M21SB GAM5B0B30M21EA
GAM5B0B36M31SB GAM5B0B36M31EA
GAM5B0C42M31SB GAM5B0C42M31EA
GAM5B0C48M41SB GAM5B0C48M41EA
GAM5B0C60M51SB GAM5B0C60M51EA
Note: “Graphics in this document are for representation only.
Actual model may differ in appearance.”
Convertible Air Handlers
1-1/2 – 5 Ton

Trane Technologies GAM5B0C60M51SB Specifications

General

Brand	Trane Technologies
Model	GAM5B0C60M51SB
Category	Air Handlers
Language	English

Summary

Safety Information

Safety Warnings and Precautions

Covers electrical, hazardous vapors, corrosion, sharp edges, and chemical exposure warnings.

Unit Design and Construction

Unit Preparation for Installation

Initial Unit Checks

Steps to check for damage and prepare the unit before installation.

Unit Placement

Carrying the Unit

Location Considerations

Vertical Installation

Vertical Installation Requirements

Horizontal Installation

Horizontal Installation Requirements

Duct Work Connection

Duct Connection Guidelines

Guidelines for connecting supply and return air ducts to the unit.

Refrigerant Line Brazing

Brazing Refrigerant Lines

Step-by-step instructions for brazing refrigerant lines to the indoor coil.

Condensate Drain Piping

Condensate Drain Considerations

Connecting Condensate Drains

Instructions for connecting condensate drain piping for various configurations.

Low Voltage Electrical Connections

Low Voltage Wiring Guide

High Voltage Electrical Connections

High Voltage Power Supply

High Voltage Wiring Guide

Securing the Coil Assembly

Filters and Airflow

Filter Installation and Maintenance

System Start Up

System Charge Adjustments

Guidelines for system charge adjustments based on indoor/outdoor unit matches.

System Start Up

Start-Up Procedure

Step-by-step instructions for powering on and starting the system.

Checkout Procedures

Final Checkout Checklist

Checklist for final operational checks and system verification.

2-Stage Outdoor Adjustment

AC Model Adjustments

Settings for 2-stage AC models based on OD/ID model matches.

HP Model Adjustments

Settings for 2-stage HP models based on OD/ID model matches.