Trane 2TEE3C31A1000A - Page 5

Figure 5 Drip Pan Foam Removal
\
\
@
Figure 6 Horitzontal Drip Pan Removal
@
/
Figure 7 Drip Pan Bracket Removal
Installer's Guide
e. Remove the front triangular baffle from the coil
and install the 1/2" wide gasket provided per Fig-
ure 10. Trim the gasket length to fit the baffle.
Reinstall the baffle to coil, with gasket material
compressed against the coil.
f. Install the water blow-offbaffles provided on each
side of the coil with the flange at the top as
shown in Figure 10. The bottom of the baffle is to
be as close to the bottom of the coil as possible.
g. Install the 7/8" wide gasket in each side of the
drain pan as shown in Figure 11 (sect. X-X).
h. The 5 ton model (2!4TEE3C65A) requires 2 water
diverter baffles to be placed underneath the coil
on the inside edge of the drain pan. See Figure
10. Fill the bend in the baffle which fits the inner
edge of the drain pan with non-acetic acid RTV
type adhesive/sealant before installing the baffle.
i. The unit is then placed with the blower side
down and the coil is replaced on the coil channel
supports with the drain connections at the bot-
tom. The unit is now in downflow position with
front access. Do not reattach coil support tab.
j. When supplementary heaters are used, accessory
subbase (TAYBASE101 for 2/4TEE3C31A, TAY-
BASE100 for 2/4TEE3C37A, and TAYBASE102 for
2/4TEE3C40-65A) must be used. See Figure 1.
k. If a return duct is connected to the air handler, it
must be the same dimensions as the return
opening shown in the outline drawing on page
18.
1. Openings where field wiring enters the
cabinet must be completely sealed. Location
of power entry is shown on the outline drawing.
Use 2.5" clear stickers to seal all unused electri-
cal knockouts. See Figure 9.
m. After ductwork connections are made, seal air-
tight and per Local codes.
18-GE11 D1-4 5