Trane 4TWL6036A1000A Service Facts

20 pages

To Next Page

SSAAFFEETTYY WWAARRNNIINNGG

Only qualified personnel should install and service the equipment. The installation, starting up, and servicing of heating, ventilating, and air-conditioning

equipment can be hazardous and requires specific knowledge and training. Improperly installed, adjusted or altered equipment by an unqualified person

could result in death or serious injury. When working on the equipment, observe all precautions in the literature and on the tags, stickers, and labels that

are attached to the equipment.

May 2020

44TTWWLL66003366AA--SSFF--11FF--EENN

Side Discharge HP Model

For coastal applications where units are installed within one (1) mile of salt water, epoxy coated models are recommended. These models

have an 8 week lead time after order.

EEppooxxyy CCooaatteedd MMooddeell

4TWL6036A1000A

4TWL6036A1COTA

NNoottee:: “Graphics in this document are for representation

only. Actual model may differ in appearance.”

Service Facts

Other manuals for Trane 4TWL6036A1000A

Installer's Guide28 pages

Questions and Answers:

A
Amanda GonzalezAug 1, 2025
What to do if my Trane 4TWL6036A1000A compressor fails to start?
- G
  Gregory BookerAug 1, 2025
  If your Trane Air Conditioner's compressor isn't starting, there are several potential solutions. First, wait three minutes, then check the contactor and ensure there's 24 volts AC across the contactor coil. If that doesn't work, consider replacing the contactor. Also, check the low voltage transformer and control fuse. If necessary, replace the room thermostat. Finally, repair or replace the transformer or fuse, and investigate the cause of the failure, looking for potential shorts in the connecting field wiring.