4 88-A4HP5001-1B-EN
D
W
H
Section 2. Unit Location Considerations
2.1 Unit Dimensions and Weight
Table 2.1
When mounting the outdoor unit on a roof, be
sure the roof will support the unit’s weight.
Properly selected isolation is recommended to
alleviate sound or vibration transmission to the
building structure.
Unit Dimensions and Weight
Models H x W x D (in)
Weight* (lb)
A4HP5018D
32.6 X 29.8 X 29.8 162
A4HP5024D
32.6 X 29.8 X 29.8 162
A4HP5030D
28.6 X 29.8 X 29.8 159
A4HP5036D
36.6 X 34.3 X 34.3 199
A4HP5042D
44.6 X 34.3 X 34.3 227
A4HP5048D
44.6 X 34.3 X 34.3 250
A4HP5060D
44.6 X 34.3 X 34.3 250
* Weight values are estimated uncrated.
Liquid Line Connection
Access valve for compressor
suction pressure measurement
Connection
2.2 Service Valves Locations
1. The locations of the below listed valves in
the unit are shown in the figure.
a) Liquid line connection
b) Access valve for compressor suction
pressure measurement
c) Suction line connection
To Next Page
Loading...
