TAMX Replacement Air Handler Control
Board Conguration
This control board needs congured for use and will not operate
until correctly congured.
INSTALLER'S
GUIDE
IMPORTANT — This Document is customer property and is to remain with this unit. Please return to service information
pack upon completion of work.
ALL phases of this installation must comply with NATIONAL, STATE AND LOCAL CODES
18-GJ92D1-1A-EN
Model:
CNT09289 or
superseded
3. General Information
This replacement control board is used on TAMX air
handlers.
NOTE: This instruction will explain how to configure this
control board to operate.
1. Unpack all components of the kit.
2. Check carefully for any shipping damage. If any
damage is found, this must be reported immediately
and a claim made against the transportation
company.
3. Check to be sure all components are in the
package. Any missing components should be
reported to your supplier at once and replaced with
authorized components only.
Each kit will contain:
Item Qty Description
1 1 Air Handler Control Board
2 1 Installer's Guide
1. Safety Considerations
2. Inspection
IMPORTANT: Follow all Warnings and Cautions in the air
handler Installer's Guide.
THE INFORMATION IN THIS GUIDE IS FOR USE BY
INDIVIDUALS HAVING ADEQUATE ELECTRICAL AND
MECHANICAL BACKGROUND. ANY ATTEMPTS, BY
UNQUALIFIED PERSONS, AT PLUMBING, INSTALLING
OR REPAIRING A HYDRONIC SYSTEM OR CENTRAL
AIR CONDITIONING PRODUCT COULD RESULT IN
PROPERTY DAMAGE, SEVERE PERSONAL INJURY OR
DEATH. THE MANUFACTURER OR SELLER CANNOT
BE RESPONSIBLE FOR THE INTERPRETATION OF THIS
INFORMATION, NOR CAN IT ASSUME ANY LIABILITY IN
CONNECTION WITH ITS USE.
ELECTRICAL HAZARD!
DISCONNECT ALL ELECTRICAL POWER, INCLUDING
REMOTE DISCONNECTS BEFORE INSTALLING OR
SERVICING. FOLLOW PROPER LOCKOUT/TAGOUT
PROCEDURES TO ENSURE THE POWER CAN NOT
BE INADVERTENTLY ENERGIZED. FAILURE TO
FOLLOW THIS WARNING COULD RESULT IN SERIOUS
PERSONAL INJURY, DEATH, OR PROPERTY DAMAGE.
4. Kit Contents
Air Handler Control Board
To Next Page
Need help?
General
