Trane CVRE User Manual

CDUB - Symbio™ 800 Control
Upgrade Kit
For UC800 AdaptiView™ Display
Installation Instructions
August 2023
SO-SVN038A-EN
Model Number: Used With:
CDUA, CVRE UC800
CVHE, CVHF, CVHG, CVGF UC800
HDWA, CVHM, CVHH UC800
SAFETY WARNING
Only qualified personnel should install and service the equipment. The installation, starting up, and servicing of
heating, ventilating, and air-conditioning equipment can be hazardous and requires specific knowledge and training.
Improperly installed, adjusted or altered equipment by an unqualified person could result in death or serious injury.
When working on the equipment, observe all precautions in the literature and on the tags, stickers, and labels that are
attached to the equipment.
This document applies to service offering applications only.
Distribution/use of this is limited to the Trane sales and service organization in support of Symbio 800 AdaptiView and
is not intended for independent third party use or for use apart from the Symbio 800 AdaptiView display upgrade for UC800
AdaptiView display.

Trane CVRE Specifications

General

Brand	Trane
Model	CVRE
Category	Controller
Language	English

Summary

Introduction

Warnings, Cautions, and Notices

Explains the types of advisories used throughout the manual for safety.

Proper Field Wiring and Grounding

Critical safety requirements for field wiring and grounding to prevent hazards.

Personal Protective Equipment (PPE) Required

Essential PPE for technicians to prevent injury during installation and servicing.

General Information

Summary of UC800 Display Upgrade

Overview of UC800 display upgrade procedures and topics covered.

Getting Started

Hazardous Voltage w/Capacitors!

Critical safety warning about disconnecting power and discharging capacitors.

Installation

Installation of UC800 Control Upgrade

Steps for upgrading the UC800 control system.

Check the Configuration and Set-Points in the AdaptView Display

Verifies current AdaptiView configuration and chiller set-points.

Save the AdaptView Configuration and Set-Points

Hazardous Voltage and Equipment Damage!

Safety warning about hazardous voltage and equipment damage during installation.

Upgrading Display Firmware

Step-by-step instructions for upgrading the display firmware.

Update the Display Original X-CODE to Symbio Display X-CODE

Shut Down Power

Remove the Existing UC800 controller and Install New Symbio 800 Controller

Remove the Existing Display and Install New Display (When Required)

Installation of Options

Water Flow Measurement Options

Energy Meter Option Installation

Expansion Module Option

Programming

Programming the Symbio 800 AdaptiView

Guide for programming the Symbio 800 controller using Tracer TU.

Separate AC Power Required for Computers

Critical notice about using separate AC power for laptops connected to Symbio 800.

Navigating within the equipment utility configuration tab in Tracer TU

Start-Up

Wiring Diagrams