SO-SVN038A-EN 5
General Information
Other Required Manuals
This manual must be used with the following publications (or
their most recent versions):
• CenTraVac™ Water-cooled Chillers Models CVHE, CVHF,
and CVHG With Symbio™ Controls - Installation,
Operation, and Maintenance (CVHE-SVX005*-EN)
1
• CenTraVac™ Water-Cooled Chillers AdaptiView™
Display with Symbio™ Controls - User Guide
(CTV-SVU004*-EN)
1
• Tracer® TU Service Tool For Water-Cooled CenTraVac™
Chillers with Symbio™ Controls - Programming Guide
(CTV-SVP004*-EN)
1
• CenTraVac™ Water-cooled Chillers with Symbio™
Controls Diagnostic Descriptions, Troubleshooting Tables,
and Control Component Overview - Diagnostics Manual
(CTV-SVD005*-EN)
1
•Tracer® TU Service Tool - User Guide (BAS-SVU047*-
EN)
1
• Tracer Symbio Panel Upgrade - Programming Guide
(CVRF-SVP01*-EN)
Required Tools
Normal service tools are required to perform the majority of the
work. A service technician with a well stocked tool chest should
have the right tools to perform the job.
In addition to the normal service tools and hardware, the
following is a partial list of specific field supplied hardware/
software components and special tools that are also required
to perform the display retrofit:
• An RS-232 male DB9 to female DB9 pin to pin serial cable
to connect the DynaView to a PC or laptop computer.
Note: The cable must not be a null-modem cable. The
cable must be less than 50 feet in length.
– The RadioShack
®
part number for the proper cable is
26-117B.
• Type A to Type B USB cable to connect the Symbio 800
controller to a PC or laptop computer.
• A PC or laptop computer equipped with the following:
– TechView™ service software, version 12.1 or newer.
– Tracer TU service software, version 2.02 or newer.
– Rover™ service software (only required if the chiller is
equipped with a LonTalk
®
Comm5 board).
• South pole magnet screwdriver (TOL01343).
• Electronics vacuum.
Field-Provided Material
Some field provided material will be required to perform the
display retrofit. A list of material is provided here to help the
technician to plan ahead and to avoid material shortages at the
job site.
• Wire, red and green #16 AWG control wire - required to
make the connections between the power supply and
existing transformer.
• Wire connectors.
• Wire wrap or some other form of wire protection for areas
that wiring runs may come into contact with sharp edges.
• Cable ties to help clean up wiring runs.
If the unit is located outside, a cover is required for the display.
• The Trane part number for this cover is COV03916.
1
A copy of this manual is shipped with the upgrade kit.
To Next Page
Loading...
