29
Troubleshooting
11
Slow response or
unexpected operation:
Reboot your control at the
following location.
“No System Found” displays on the screen:
If this message stays on your screen, press the
“Reboot” button shown at right.
No response to any button presses:
Remove and re-install the control as shown below. The boot up process may take several minutes.
Re-Install Control
Re-install control flat onto sub-base
being careful to align unit correctly with
the sub-base before applying force.
Control should fit snug and not “rock”
when properly installed.
Remove Control
Remove control from its sub-base by
grasping at edges and gently pulling
the control straight towards you. It
should release without much effort.
To Next Page
Loading...
