MUA-SVX01A-EN
General Information
All Trane equipment has been factory tested, adjusted, metered and inspected to
meet conditions set at the time the order was placed. Only minimal adjustments
should be required. All information in this service manual is typical. All products
are semi-custom and changes may occur.
• Suggested Tools/Instruments
• Microammeter
•Volt/Ohm Meter
• Ammeter
• Tachometer
• Thermometer
• Manometer (0-10" of W.C.)
• Standard Hand Tools
• Gas Pressure Gauges (0-35 lbs.)
• D.C. Volt Meter
Replacement Parts
Replacement parts may be ordered from the local Trane Parts Counter
representative.
When parts are ordered, model number and serial number are required. Belts
and fuses are not covered by warranty.
To Next Page
Loading...
