Trane GRAA - Receiving and Installation Preparation; Receiving Instructions; Pre-Installation Instructions

Figure 3 - Roof Curb Assembly *
* The roof curb and destined unit must be sealed completely to prevent any water or air leakages (also see Figure 8).
Refer to Figures 17 and 18 for Ductwork Mounting Bracket Assembly.
1 Curb Rail Assembly—Side
2 Curb Rail Assembly—End
3 Cross Brace—Curb
4
Bolt—3/8-16 x 1" LG. Hex Hd.
(8) Req’d.
5
3/8-16 x 1" LG. Hex Nyloc Nut
(8) Req’d.
6
1/4-14 x 5/8 LG. Hex Washer
Hd. Sheet Metal Screw Type
“AB” (8) Req’d.
7
Screw—#10 x 5/8" LG. Pan
Hd. Type “AB” (8) Req’d.
8 Gasket
6 GRAA-IN-1