RT-PRC010-EN96
Options
Coils
Black epoxy evaporator coils X
Copper finned evaporator coils X
Copper finned condenser coils (20-75 tons only) X
Copper finned condenser coils (90-130 tons only) X
Heresite treated condenser coils X
High capacity evaporator coils (20 to 105 tons) X
Pre-heat Coil X
Condenser
Evaporative-cooled condenser X
Controls
Generic BAS (Building Automation System) interface X
Inlet guide vanes on FC supply fans (Variable Air Volume (VAV) only) X
Inter-Processor Communication Bridge X
Kits available for field control upgrades X
No Controls X
Remote Human Interface Panel (controls up to 4 units) X
Remote minimum position control for economizer X
Single zone VAV with Johnson S350 controller or terminal strip control X
TRAQ sensing with ventilation control module X
Trane Communication Interface Module: ICS interface control module X
Variable frequency drive (VFD) control of supply/exhaust fan motor X
Ventilation override module (five ventilation override sequences) X
Curbs
Roof curbs X
Roof curbs—Special design, including curbs for “twinning” large units together X
Dampers
0-25 percent manual dampers X
Barometric relief exhaust dampers X
Low ambient control dampers—0 degrees F (20–75 tons) X
Low ambient control dampers (90–130 tons) X
Ultra low leak dampers for 0-100 percent modulating fresh air economizer X
Drain Pans
Positively sloping evaporator coil drain pan X
Stainless steel positively sloping evaporator coil drain pan X
Enhanced
Design
Facility
Special
2 3
Standard
Factory
Design
Special
2 3
Option or Accessory
Standard
Field
Installed
Accessory
Table O–1 Comprehensive Listing of Available Options and Accessories
1