Trane Mini

9
Mini / Multi-Split Programmable Controller
3.3 On/Off
3.4 Mode Setting
3.5 Temperature Setting
3.6 Fan Setting
F
79
/
/ 4
6
F
COOL
79
/ / 4
6
When the wired control is on the main screen, press the ON/OFF button to turn on
the unit. Press the ON/OFF button again to turn off the unit. The displays in both ON and
OFF states are shown in Fig. 4 and Fig. 5.
Fig. 4 Unit OFF display Fig. 5 Unit ON display
When the unit is on, pressing the MODE button will cycle through the operating
modes as shown below:
(COOLING) (DRY) (FAN) (HEATING)
(AUTO)
Note: If the energy SAVE function is set to be on, AUTO mode will not be available. (The
energy-save function is not available on current units.)
When the unit is on, pressing the “▲” or “▼” button on the main page increases
or decreases the set temperature by 1°F(1°C); holding the “◀” or “▶” button
increases or decreases the set temperature by 1°F(1°C) every 0.3 seconds.
In cooling, dry, fan and heating mode,temperature setting range is 61°-86°F
(16°-30°C). In AUTO mode, the set temperature cannot be adjusted.
When the unit is on, pressing the FAN button will cycle through the fan speeds as
shown below:
Low→Medium→High→Turbo→Auto→Low
Symbols displayed are as shown in Fig. 6.
TURBO AUTO
Fig. 6 Fan Setting