ALL phases of this installation must comply with NATIONAL, STATE AND LOCAL CODES
Important: This Document is customer property and is to remain with this unit.
The JMM4A series wall mount air handler is
designed for installation in a closet, utility room,
alcove and can be wall mounted. These versatile units are applicable to air conditioning
applications. Field installed electric resistance heaters are available.
•
5, 7.5 and 10 kW SINGLE PHASE ELECTRIC
HEATERS
- Circuit breakers are standard on all single
phase 5,
7.5 and 10 kW heaters.
• All aluminum coil.
• Factory installed piston style refrigerant control-
Field installed TXV kits available.
• Blower and coil slide out easily for maintenance.
• Factory-sealed cabinet certified to achieve 2% or
less air leakage rate at 1.0 inch water column.
• Front or bottom return air.
• Painted finish on galvanized steel.
• Sturdy polycarbonate drain pans.
- Air handler has factory installed drain pan and
is shipped for upflow applications only.
• 208/230 VAC operation.
• Stud or wall mount installation.
• Fully insulated cabinet.
• 3/4'' NPT primary and secondary drains.
• AHRI certified and ETL listed.
A
18-GF12D1-1A-EN
JMM4A0A18S21SAA
JMM4A0A24S21SAA
JMM4A0B30S21SAA
JMM4A0B36S31SAA
To Next Page
Need help?
General
