To Next PageTo Next PageWhat to do if Trane Chiller unit does not start?
If your Trane Chiller unit isn't starting, begin by verifying the power supply and inspecting the protection systems upstream. Ensure the unit's master switch is set to ON and the circuit breaker is also ON. If these steps don't resolve the issue, the electronic board, contactor, or compressor might be damaged, requiring component replacement.
Why is my Trane Picco R32-270 unit yeld poor?
A poor yield from your Trane Chiller could be due to an insufficient amount of refrigerant or an improperly sized plant system. Checking these aspects is recommended.
Provides critical safety information regarding the R32 refrigerant used in the unit.
Highlights specific safety precautions related to the R32 refrigerant.
Details essential PPE required for maintenance and safe operation of the unit.
Provides guidelines for unit placement and required clearance distances for optimal operation.
Specifies acceptable chemical-physical properties for the unit's water circuit.
Details power supply specifications and connection precautions.
Explains the connections for the user terminal block.
Details recommended cable sections and tightening torques for power supply.
Checklist of essential checks before starting the unit.
Steps for powering on and starting the unit.
General safety and procedural precautions for maintenance.
Specifies conditions for heat pump performance data according to standard 14511:2018.
Details cooling capacity, power input, and efficiency ratings for different models.
Details heating capacity, power input, and efficiency ratings for different models.
Specifies minimum and maximum water flow rates for the evaporator.
Explains the unit's display, LEDs, and their operational meanings.
Identifies causes and solutions for the unit not starting.
Addresses issues with compressor start-up due to protective devices.
General
