To Next PageTo Next Page
Need help?Do you have a question about the Trane RTAA-170 and is the answer not in the manual?
Instructions for reporting damage and providing an installation check sheet.
Guidelines for selecting an appropriate installation location for the unit.
Specifies requirements for mounting pads or concrete foundations supporting the unit.
Details required clearances around the unit for installation and service access.
Steps to protect the domestic water heater system from freezing in subfreezing ambient temperatures.
Explains system arrangements and elevation roles in determining line sizes.
Provides examples and tables for sizing liquid lines based on equivalent length.
Explains how to determine the system's required refrigerant charge.
Describes how to calculate the amount of additional oil needed for field-installed piping.
Provides warnings and code compliance advice for electrical wiring.
Explains field-supplied inputs for pump interlock and external auto/stop functions.
Details connecting a remote resistor/potentiometer for CWS, including calibration.
Details connecting a remote resistor/potentiometer for CLS, including calibration.
Details the motor and rotor components of the helical rotary compressor.
Explains how the UCM starts and balances compressor load based on demand.
Explains how the UCM modulates slide valves to prevent exceeding the Current Limit Setpoint.
Prevents unit start-up when outdoor air temperature is below the setpoint.
Procedure to test the proper operation of the electronic expansion valve.
Details how the UCM monitors compressor current to protect against overcurrent conditions.
Explains how the UCM controls to the setpoint by staging compressors and modulating slide valves.
Explains how to measure and interpret normal superheat at full operating load.
Details how to measure and interpret normal subcooling for each circuit.
General
