Need help?Do you have a question about the Trane RTAD 100 HE and is the answer not in the manual?
Technical specifications for standard RTAD units (SI).
SI specifications for RTAD units with high static pressure.
Technical specs for RTAD Standard units (English).
SI specs for RTAD units with low noise configurations.
SI specs for low noise RTAD units with night setback.
SI specs for RTAD units with high static pressure.
SI specs for standard heat recovery RTAD units.
SI specs for high efficiency heat recovery RTAD units.
SI specs for low noise heat recovery RTAD units.
SI specs for standard low noise heat recovery RTAD units.
SI specs for high efficiency low noise heat recovery RTAD units.
Contractor's duties for proper unit installation.
Overview of LonTalk interface, wiring, and network variables.
Schematic diagram of system and oil flow for standard/PHR units.
Schematic diagram illustrating the system for free-cooling units.
Schematic diagram for total heat recovery units.
Checklist to verify installation completeness before unit startup.
Verifying supply voltage, imbalance, and phase sequence.
Describes the sequence of operations for a typical unit startup.
Managing refrigerant and oil for unit reliability and performance.
General| Model | RTAD 100 HE |
|---|---|
| Refrigerant | R-134a |
| Cooling Capacity | 100 tons |
| Power Supply | 460V/3/60Hz |
| Water Flow Rate | 240 GPM (Typical) |
To Next Page
