Module Power and Miscellaneous I/O
68 RTHC-SVD01B-EN
13-3 b. Select Report Group
This group of four keys allows the operator to select and view the fol-
lowing reports:
[ ] Custom Report
[ ] Chiller Report
[ ] Refrigerant Report
[ ] Compressor Report
The Custom Report is the only report that is defined by the operator.
Any display under the other three reports can be added to the Custom
Report by pressing the plus (+) key while the desired read-out is on the
display. A maximum of 20 entries can be contained under the Custom
Report. Items can be deleted from the Custom Report by pressing the
minus (-) key when the desired read-out is on the display. The operator
must be in the Custom Report menu to delete the desired item.
The Chiller, Refrigerant and Compressor Reports are informational
reports showing current status. Each report and its contents are dis-
cussed in detail on the following pages.
When any of the four report keys are pressed, the first readout on the
display will be the header. The header identifies the title of the report
and summarizes the items in the report. If the headers are disabled the
display will be the display listed after the heading.
The Next and Previous keys allow the operator to scroll up and down
through the display items listed under the report menus. When the last
item of a report is displayed and the Next key is pressed, the display
will wrap around to the header of the report. When the first item of a
report is displayed and the Previous key is pressed, the display will
wrap around to the last item.
13-3 c. Select Settings Group
The first three keys on the second row - Operator Settings, Service
Settings and Service Tests - allow the operator to adjust various set-
points and perform various tests. Certain items in these groups are
password protected. Refer to the Password section for additional infor-
mation.
When a setpoint key is pressed, a header will be displayed.The set-
point headers identify the available items and setpoint functions.
The Next and Previous keys function in the same manner as that
described in Select Report Group, above.
To Next Page
Loading...
