100 RT-SVP07B-EN
CONFIGURATION Menu
Configuration - Model Num Digit 21 or 31
Ventilation Ctrl (VCM) CONFIG REQ'D
Used With: All Units
Possible Values:
Vent. Ctrl (VCM) NOT INSTALLED
Fresh Air Meas. (VCM)w/DCV OPTION
OA Damp Min Pos (VCM)w/DCV
OPTION
Notes:
1. A VCM module will be required installed if: “Fresh Air
Measurement (VCM) w/DCV OPTION” is selected, or
2. “OA Damper Min Pos (VCM) w/DCV Option” is selected and DCV
Control in the setup menu is set to ENABLED.
• Press Next/Previous keys to navigate.
Configuration - Model Num Digit 21 or 23
Comparative Enthalpy: INSTALLED
Used With: All Units
Possible Values:
NOT INSTALLED
INSTALLED• Press Next/Previous keys to navigate.
Configuration - Model Num Digit 24
Final Filters: INSTALLED
Used With: IPak II Units
Possible Values:
NOT INSTALLED
INSTALLED• Press Next/Previous keys to navigate.
Configuration - Model Num Digit 25
Energy Recovery: NOT INSTALLED
Used With: IPak II Units
Possible Values:
NOT INSTALLED
INSTALLED W/O PREHEAT
INSTALLED W/ PREHEAT
Note: “Energy Recovery” is not permitted to be installed here if
“Return Fan…” option above is set to INSTALLED.
• Press Next/Previous keys to navigate.
Configuration - Model Num Digit 27
Condenser Type: Air-Cooled
Used With: IPak II Units
Possible Values:
AIR-COOLED
WATER-COOLED W/O SUMP HT
WATER-COOLED WITH SUMP HT
Note: This selection must match the physical unit configuration or
improper operation and unit damage may occur. “Sump HT” refers
to the Sump Heater installation.
• Press Next/Previous keys to navigate.
To Next Page
Loading...
