52 RT-SVP07B-EN
STATUS Menu
End of Submenu (Next) to enter Status
• Press Next/Previous keys to navigate.
GBAS (10VDC) MODULE STATUS SUBMENU SCREENS
GBAS (10VDC) Module Status Submenu
Press ENTER to View Data in This Submenu
Used With: Units w/GBAS (10VDC)
Installed
• Press the Next key to skip this Submenu.
GBAS (10VDC) Analog Input 1 0.00 VDC
Assigned: NOT ASSIGNED
Used With: Units w/GBAS (10VDC)
Installed
Possible Values:
Input: 0.0 to 10.0 VDC
Bottom Right Field:
[See GBAS(5VDC) Above for
Assignments]
Note: There will be 4 screens shown for this configuration. The first
screen will be for Input 1 setpoint assignment. The next screens
will be identical and will show setpoint assignments for Input 2,
Input 3, and Input 4.
• Press Next/Previous keys to navigate.
GBAS (0-10VDC) Demand Limit Input Status
Open
Used With: Units w/GBAS (10VDC)
Installed
Possible Values: Open, Closed
• Press Next/Previous keys to navigate.
GBAS (0-10VDC) Binary Output 1 OFF
Assigned: OUTPUT IS NOT ASSIGNED
Used With: Units w/GBAS (10VDC)
Installed
Possible Values: Output: ON, OFF
Bottom Right Field:
OUTPUT IS NOT ASSIGNED
INDICATE ANY COMP IS RUNNING
INDICATE UNIT AT MAX CAPACITY
INDICATE SELECTED DIAG ALARMS
[See “Alarm Listings” in RTM Alarm
Outputs Below]
• Press Next/Previous keys to navigate.
To Next Page
Loading...
