RT-SVP07B-EN 75
SETUP Menu
RTM ALARM OUTPUT DIAGNOSTIC ASSIGNMENTS SCREENS
RTM Alarm Output Setup Submenu
Press ENTER to Review or Adjust
Used With: All Units
• Press the Next key to skip this Submenu.
If Enter was pressed, proceed to the following 3 screens.
Assign Diagnostic to Alarm Output?
Any Active Diagnostic (Yes)
Used With: All Units
Possible Values: Yes, No
Note: If “Yes” is selected at this screen, any active diagnostic will
activate this output. A selection of “No” will allow the user to choose,
from the following menus, which diagnostics activate the Alarm
Output.
If No was entered, proceed to the following 2 screens.
Assignment Submenu - RTM Alarms
Press ENTER to Review or Adjust
Used With: All Units and Any Active
Diagnostic Set to “No”
Note: Please review the “Diagnostics
Troubleshooting Chart” in the
“DIAGNOSTICS Menu” section to see the
list of diagnostics associated with each
module. (Refer to the “Diagnostics
Displayed” column for the specified
module.)
Pressing the Next key will allow the user to skip this submenu.
Pressing the Enter key will allow the user to select any of the
diagnostics associated with the RTM module to activate the
associated Alarm Output.
Note: The user will be presented with similar Assignment Submenus
for the following alarm sources: “SCM/MCM Alarms”, “HEAT Alarms”,
“ECEM Alarms”, “VOM Alarms”, “VCM Alarms”, “GBAS Alarms”, “MDM
Alarms”, “MPM Alarms” and “BAS/Network Alarms”.
If Enter was pressed, proceed to the following screen.
Assign Diagnostic to Alarm Output?
RTM Zone Temp Sensor Failure (Yes)
Used With: All Units and the ENTER Key
Was Pressed At The Prior Screen
Selecting “Yes” for each of the diagnostics displayed will activate the
associated Alarm Output when that diagnostic is activated.
Note: The list of diagnostics displayed here will be dependent upon
the Assignment Submenu selected. See the “Diagnostics
Troubleshooting Table” in the diagnostics menu section for the list of
diagnostics displayed for each module.
• Press Next/Previous keys to navigate.
End of Submenu (NEXT) to Enter SETUP
• Press the Next key to navigate forward.
To Next Page
Loading...
