46 RT-SVX25C-EN
Maintenance
6. Spray the leaving-airflow side of the coil first; then spray the opposite side of the coil. Allow the
cleaning solution to stand on the coil for five minutes.
7. Rinse both sides of the coil with cool, clean water.
8. Inspect both sides of the coil; if it still appears to be dirty, repeat Steps 6 and 7.
9. Reinstall all of the components and panels removed in Step 1 and any protective covers
installed in step 2.
10. Restore the unit to it’s operational status and check system operation.
Final Process
For future reference, you may find it helpful to record the unit data requested below in the blanks
provided.
(1) Complete Unit Model Number:
______________________________________________________________________
______________________________________________________________________
(2) Unit Serial Number:
______________________________________________________________________
______________________________________________________________________
(3) Wiring Diagram Numbers (from unit control pane
— schematic(s)
______________________________________________________________________
______________________________________________________________________
______________________________________________________________________
______________________________________________________________________
______________________________________________________________________
______________________________________________________________________
______________________________________________________________________
— connection(s)
______________________________________________________________________
______________________________________________________________________
______________________________________________________________________
______________________________________________________________________
______________________________________________________________________
To Next Page
Loading...
