Product Application
This Comfort Control provides electronic control of 24 VAC single-stage heating
and cooling systems.
System Types
• Gas, oil or electric heat with
air conditioning
• Warm air, hot water, high-efficiency
furnaces, heat pumps
• Heat only with fan
• Cool only
Power
• Common wire only
• Common wire with battery backup
Changeover Options
• Selectable manual or
auto-changeover modes
System Settings
• Heat, Off, Cool, Auto
Fan Settings
• Auto, On
Must be installed by a trained, experienced technician
• Read these instructions carefully. Failure to follow these instructions can
damage the product or cause a hazardous condition.
• Check the ratings in this booklet to verify that this product is suitable for your
application (see page 12).
• Always test for proper operation after installation (see page 8).
CAUTION: ELECTRICAL HAZARD
Can cause electrical shock or equipment damage. Disconnect power before
beginning installation.
MERCURY NOTICE
If this product is replacing a control that contains mercury in a sealed tube, do not
place the old control in the trash. Contact your local waste management authority
for instructions regarding recycling and proper disposal.
To Next Page
Loading...
Need help?
General
