To Next PageTo Next Page
Need help?Do you have a question about the Trane TUH1B080A9H31C and is the answer not in the manual?
General| Model | TUH1B080A9H31C |
|---|---|
| Type | Gas Furnace |
| AFUE Rating | 80% |
| Stages | Single Stage |
| Gas Type | Natural Gas |
| Ignition Type | Hot Surface Ignition |
| Installation Type | Upflow |
| Heating Capacity | 80, 000 BTU/hr |
| Filter Type | Standard |
| Weight | 120 lbs |
Critical safety precautions for installation, operation, and servicing.
Addresses CO hazards and specific steps for safe venting operation.
General guidelines and recommendations for installing the furnace unit.
Specifies requirements for furnace placement and clearances to combustible materials.
Details general venting requirements, materials, and common venting system corrections.
Tables detailing maximum allowable vent and inlet air pipe lengths for various models and pipe sizes.
Tables specifying maximum vent pipe lengths for downflow/horizontal configurations.
Tables detailing required clearances for vent terminals based on location and installation type.
Tables detailing required clearances for non-direct vent terminals.
Mandates installation of CO detectors and outlines specific placement rules.
Lists locations where the furnace vent shall not terminate.
Instructions for connecting condensate drain tubing for upflow furnace configurations.
Covers national codes, local regulations, and requirements for gas piping installation.
Procedures for checking input rate, gas flow, and adjusting the gas valve.
Describes the heating cycle and procedure for checking the limit switch.
Explains integrated furnace control error codes and provides safety warnings.
