32-5093-03 page 27
Adding/Removing Z-Wave Devices (via XL1050)
Your XL1050 is designed to integrate seamlessly
with a Nexia™ smart home system.
Adding Z-Wave Devices
1. From the HOME Screen, press MENU, then
press NEXIA.
2. Press ADD DEVICE and follow the device
manufacturer’s instructions for setting the
Z-Wave device into learn mode. You will
have four minutes to set the device into
learn mode after pressing the ADD DEVICE
button.
Removing Z-Wave Devices
1. From the HOME Screen, press MENU, then
press NEXIA.
2. Press REMOVE DEVICE and follow the
manufacturer’s instructions for setting the
Z-Wave device into learn mode. You will
have four minutes to set the device into
learn mode after pressing the REMOVE
DEVICE button.
Advanced Z-Wave Settings
Press ADVANCED for advanced Z-Wave
functions including unregistering your bridge
from Nexia or factory resetting your bridge. See
the Advanced Z-Wave Settings section for more
information.
Z-Wave Bridge
Remove
Device
Add
Device
Advanced
Home Back
Connected to Nexia
Z-Wave network active with 2 nodes
To Next Page
Loading...
