18-BC100D1-1C-EN
7
Table 3. Suggested Locations for Best Reliability (continued)
$ ´ PLQLPXP FOHDUDQFH LV UHTXLUHG RQ WKH OLQH YROWDJH HOHFWULFDO
VHUYLFH VLGH DFFHVV SDQHO WR DQ\ ZDOO RU REVWUXFWLRQ
)RU HDVH RI VHUYLFH PDLQWHQDQFH SURYLGH ´ FOHDUDQFH LQ IURQW RI
WKH FRQWURO ER[ DFFHVV SDQHO DQG DQ\ RWKHU VLGH UHTXLULQJ
VHUYLFH
A 36” minimum clearance is required from
service pan
el to additional units or other
obstructions.
A 12” clearance is suggested for obstructions
above the unit.
Note: 12”
clearance not required with stacking kit.
A 2” minimum clearance is required to allow for
removal of top
Table 4. Refrigerant Piping Limits
7KH PD[LPXP OHQJWK RI UHIULJHUDQW OLQHV IURP RXWGRRU WR LQGRRU
XQLW VKRXOG 127 H[FHHG IHHW
7KH PD[LPXP YHUWLFDO FKDQJH VKRXOG QRW H[FHHG IHHW LQ PRVW
DSSOLFDWLRQV
6HUYLFH YDOYH FRQQHFWLRQ GLDPHWHUV DUH VKRZQ LQ ³5HIULJHUDQW
/LQH DQG 6HUYLFH 9DOYH &RQQHFWLRQ 6L]H &KDUW´
,PSRUWDQW )ROORZ VXEFRRO FKDUWV IRU VSHFLILF RSHUDWLRQ
50’
Max
Vertical
Change
Standard
Line Set
150’ Max
Line Length
5
0’
Max
Ve
rtical
Change
UUnniittLLooccaattiioonnCCoonnssiiddeerraattiioonnss
To Next Page
Loading...
