Need help?Do you have a question about the Trane WSC036E and is the answer not in the manual?
General| Model | WSC036E |
|---|---|
| HSPF Rating | 8.2 HSPF |
| Refrigerant | R-410A |
| Compressor Type | Scroll |
| Cooling Capacity | 36000 BTU/h |
| Voltage | 208/230V |
| Phase | 1 |
Warns about high pressure refrigerant, R-410A specific hazards, and proper handling.
Warns about electrical hazards, capacitors, and UV light dangers.
Warns about protecting the unit and roof from oil and refrigerant exposure.
Guides on inspecting the unit upon arrival for damage and shortages.
Explains the necessity of proper clearances for serviceability and efficiency.
Provides safety guidelines and first aid for handling fiberglass insulation.
Details safety warnings for lifting, unit weights, and load distribution.
Specifies requirements for unit foundations and roof support.
Details steps for verifying and installing the roof curb correctly.
Provides instructions and safety warnings for rigging and lifting the unit.
Summarizes key steps for successful commercial unit installation.
Guides on connecting the main electrical power supply to the unit.
Explains how to configure the condensate drain for front or base exit.
Explains wiring for the optional through-base electrical connection.
Warns about control transformer hazards and provides safety instructions.
Details low voltage wiring for system sensor smoke detectors.
Provides guidance on connecting ductwork, including flexible connectors and weatherproofing.
Warns about maintaining clearances from combustible materials to prevent fire hazards.
Covers wiring requirements for electric heat and low voltage controls.
Emphasizes the mandatory use of copper conductors for unit wiring.
Guides on routing and securing field-installed control wiring.
Covers wiring guidelines for 24 VAC controls and DC analog signals.
Details standard wiring procedures for the main unit power connection.
Details how to measure and calculate voltage imbalance for motor protection.
Reiterates electrical safety precautions before starting the unit.
Explains how to check and correct three-phase motor electrical phasing.
Details how to verify proper airflow for belt drive fans.
Details how to verify proper airflow for 5-tap direct drive fans.
Details how to verify proper airflow for two-speed direct drive fans.
To Next Page
