Transcell Technology TI-700K - Adjusting Time and Date on Printout

12
Adjusting the Time and Date on the Printout
This indicator will keep track of the current time and date, which can then be printed on the print
ticket. To adjust the time and date, you must first enter the User Menu Mode.
1. Press and hold the MENU/OFF key to switch off the digital indicator.
2. Press and hold the ON key until the digital indicator beeps and starts to boot up.
3. During the countdown phase (“555555, 444444”, etc.) press and hold the MENU/OFF key
until the “Set?” message is displayed.
4. Press the NET/GROSS button while “Set?” is being displayed.
The digital indicator displays “- F – “.
5. Press the PRINT (right) key once. The screen displays “-A1-”.
6. Scroll down using the ZERO (down) key to reach the parameter level. The digital indicator
shows “A1-1”.
7. Move from A1-1 to A1-20 by pressing the TARE (left) key repeatedly until the screen shows
“A1-20”.
8. Once you have arrived at A1-20 press the ZERO (down) key once. The screen displays
“ho_xx” where ‘xx’ is the current hour, e.g. “15”. One digit will be flashing.
9. Use the four directional keys to adjust the displayed value to the actual hour value. Increase
the flashing digit by pressing the UNITS key. Decrease the flashing digit by pressing the
ZERO key. Pressing the TARE key or the PRINT key will change the position of the flashing
digit.
10. After entering the exact value, press the NET/GROSS key to save the value. The screen
displays “n¬_xx” where ‘xx’ is the current minute, e.g. “55”. One digit will be flashing.
11. Use the four directional keys to adjust the displayed value to the actual minute value. In-
crease the flashing digit by pressing the UNITS key. Decrease the flashing digit by pressing
the ZERO key. Pressing the TARE key or the PRINT key will change the position of the
flashing digit.
12. After entering the exact value, press the NET/GROSS key to save the value. The screen
displays “dA_xx” where ‘xx’ is the current day of the month, e.g. “14”. One digit will be flash-
ing.
13. Use the four directional keys to adjust the displayed value to the actual day value. Increase
the flashing digit by pressing the UNITS key. Decrease the flashing digit by pressing the
ZERO key. Pressing the TARE key or the PRINT key will change the position of the flashing
digit.
14. After entering the exact value, press the NET/GROSS key to save the value. The screen
displays “n¬_xx” where ‘xx’ is the current month of the year, e.g. “02”. One digit will be flash-
ing.
15. Use the four directional keys to adjust the displayed value to the actual month value. In-
crease the flashing digit by pressing the UNITS key. Decrease the flashing digit by pressing
the ZERO key. Pressing the TARE key or the PRINT key will change the position of the
flashing digit.
16. After entering the exact value, press the NET/GROSS key to save the value. The screen
displays “yE_xx” where ‘xx’ is the current month of the year, e.g. “11”. One digit will be flash-
ing.