TransCore encompass 4 - Page 18

Quick Start Guide
TransCore Proprietary 18
Table 11 Frequently Used Reader Commands
Enter Reader Response What It Does
#48N #Done Select tag mode
N = 0–9
0 = disable ATA
1 = enable ATA
2 = disable eGo
3 = enable eGo
4 = disable SeGo
5 = enable SeGo
6 = disable IAG
7 = enable IAG
8 = disable eATA
9 = enable eATA
NOTE: Encompass 4 Reader will only have tag
protocols specific to the model ordered.
#505 #Model [model]
Ver [version no.] SN [serial no.]
Display firmware version
#527 #RFST Cx Ox T1 Fxx Rxx Gxx Axx Ixx
C0 = RF controlled by host, see #6400,
#6401
C1 = RF-by-input control, see #641
O0 = RF o, see #6400
O1 = RF on, see #6401
T1 = uniqueness timeout of 2 min, see
#441
Fxx = RF output frequency 00 to 34, (see
#642NN, #647XXX
Rxx = ATA RF output range, 00 to
1F (Default = 1F = max range), see
#643NN
Gxx = eATA SeGo/eGo range control, 00
to 1F
(Default =1F = max range) , see #645NN
Axx = RF power attenuation, 00 to
0A (Default = 00 = Max Power), see
#644NN
Ixx (IAG Attenuation) = 00-0F (04
Default) 00=Max Power, see #646NN
Display RF status