Transition Networks E-100BTX-FX-05 - Installation; 4-Position DIP Switch

Transition Networks E-100BTX-FX-05 User Guide
33210 Rev. R http://www.transition.com/ Page 4 of 17
Installation
CAUTION: Wear a grounding device and observe electrostatic discharge precautions when setting the
4-position DIP switch and jumpers. Failure to observe this caution could result in failure of the media
converter.
4-Position DIP Switch
The 4-position DIP switch is located on the side of the media converter. Use a small flat-blade screwdriver
or a similar tool to set the recessed switches.
1. Auto-Negotiation
up Enables Auto-Negotiation for the copper connection.
down Disables Auto-Negotiation for the copper connection.
2. Pause Control
up Enabled
down Disabled
3. Link Pass-Through
up Enabled
down Disabled
4. Far-End Fault
up Enabled
down Disabled