Transpak Atlantis TP-701 - Table of Contents

TP-701 / TP-701P Q&A
Confidential TO: FROMM HOLDING AG Page 1 of 23 8/19/2008
CONTENTS
I. Check the followings when machine malfunctions ...............................................................2
II. The Ready Lamp on operation panel can not be on...................................................................3
III. Strap doesn’t reach the sealing point cause machine malfunction (strap track open) ...............4
IV. Too much or insufficient strap in the pool box lead to short feed problem...............................8
V. Strap doesn’t join after strapping .............................................................................................10
VI. Insufficient strapping tension...................................................................................................13
VII. Four corners of Bandway Group doesn’t move at the same time............................................15
VIII. After strapping PP strap doesn’t get cut completely................................................................16
IX. Machine stops during strapping, and the green light of the Start Switch (T6-6-10301) keeps
flashing.....................................................................................................................................16
X. Strap get sealed but doesn’t do reversing (or incomplete reversing) when strapping .............18
XI. Strap doesn’t reach the sealing point when doing ASF ...........................................................20
XII. Press bar’s movement is unsmooth..........................................................................................23