Genesis TP-501/TP-502 Q&A
Confidential TO: FROMM HOLDING AG
Page 1 of 8 8/19/2008
CONTENTS
I. Machine is out of service: ...........................................................................................................2
II. Machine could not stop at the home position: ............................................................................3
III. Machine keeps feeding strap:......................................................................................................4
IV. Sealing with a result of bad quality:............................................................................................4
V. When you turn on the machine, machine fails to make sealing right after Ready Lamp
(T5-4-10260) has lit up. Sealing will be back to normal again after you wait for awhile:......5
VI. Machine fails to cut off PP straps: ..............................................................................................6
VII. Tension is still too high even when the tension knob is set before 10 o’clock position: ............6
VIII. Machine starts to seal before a complete tensioning: .................................................................7
IX. Straps are not refeeded after machine completes a strapping cycle:...........................................7
X. Tension with a result of bad quality:...........................................................................................8
To Next Page
Loading...
