-15-
(2) Maintenance
Only use original spare parts supplied by manufacturer.
Daily:
Use air gun to clean the circled positions (nearby the cutters, strap guide daily
Remove plastic residue in the machine.
Weekly:
Lubricate front bar, press bar and rear bar weekly.
Please refer to the above mesh areas for instruction.
Before lubricating, be sure to clean the parts first to avoid mixing oil and debris which
might have a bad effect on machine’s function.
Monthly :( or 3,000 strapping cycles)
Clean both sides of heater plate and polish with fine sandpaper if necessary
ATTENTION: Make sure the welding plate is cool first!!
Check cam rollers of seal head for easy movement. Slide table back to home position
automatically by the spring tension.
Be sure to clean any debris in the tension roller
6 Months:（or 18,000 strapping cycles）
Check heater plate, replace and readjust it if necessary.
Check strap cutter in seal head, replace it if necessary.
Check that connector at wiring loom to printed circuit board is firmly fixed.
Make machine ready for operation. Strap one bundle manually several times, paying
attention to mal-functions, repeat procedure.
Air Air
To Next Page
Loading...
