-6-
Environment Information
The strapping machine shall be installed in the following conditions:
Supply voltage: 0.9 - 1.1 nominal supply voltage
Source frequency: 0.99 - 1.01 nominal frequency
Ambient temperature: 5°C - 40°C (41℉-104℉).
Relative humidity: not exceed 50% at 40°C.
Please provide a suitable illumination around the machine for safety operation.
(2) The Safety Devices
Caution!
The heating unit operates at a very high temperature in order to melt the P.P. strapping.
To prevent burns, avoid contact with this area. (1)
To move the machine, the two lockable casters (2) must be unlocked. Relock the two
casters when the machine is in its new position.
Description of the Safety Devices
The machine is turned on when it is connected to AC power and the main power switch
(QS1), located on the front operating panel, is placed in the ON position. After
approximately 3 minutes, the heating element will reach its operating temperature and the
machine will be ready for use.
If it is necessary to make adjustments inside the machine during operation, after a strap
jam for example, the table top can be unscrewed. Observe caution as the machine is still
fully functional with the covers removed. If machine with safety switch, when table top is
opened, safety switch is activated. This will remove power but heating element is keeping
heating.
1
2
To Next Page
Loading...
